You ll need 18 inches of tie wire for each intersection of wire and post.
Fixing barbed wire fence with hammer.
Next put the splice wire across the neck of the hammer then around the side and down between the claws.
Instructional video on how to fix a break and tighten a barbed wire fence using number 9 wire and a claw hammer.
You ll find them in any fencing store.
To start the splice make a loop in one end of the broken wire and run an additional piece of material through the loop.
Holding staples in place with needle nose pliers is a good idea.
If you had a big project using staples wire fence stapler is the best tool for you.
Use a fence stretcher to pull together enough wire to make the repair.
Slide each wire end through one of these inexpensive sleeves as shown in this photo.
Once a fence is damaged it has to be repaired immediately.
Before getting started on fixing a strand of barbed wire assess whether the fence can be fixed or if it should instead be replaced.
Remove the staples from the old post using the claw end of your hammer.
Place the hammer against the wire and anchor the loose end between the hammer claw.
Strands of barbed wire will sometimes snap.
While standing in front of the upright on the barb side wrap the plain wire around the horizontal strand on the left side.
Then from each half of the break remove any barbs for about 6 to 8 inches.
If there are rust spots along the barbed wire strand or multiple breaks in the strand it may be better to call your local farm fencing supplier and order a new strand of barbed wire.
Then roll the wire around the hammer making as many twists as necessary to get the wire very tight.
The broken ends of the barbed wire are folded into loops.
Temporary repair particularly for broken barbed wire is usually a baling wire splice.
Baling wire is then threaded through the loops pulled as tightly as possible and wrapped off.
Step 2 fixing broken wire.
Pull the splice wire through the loop as far as you can then lay the neck of your hammer which exists between the head and the claws underneath the splice wire and across the loop.
Attach the barbed wire to the new post with fresh wire staples.
