How to install sliding wardrobe doors by spacemaker wardrobes.
Fitting sliding wardrobe doors on carpet.
Instructions on how to fit the soft close mechanism to the doors and top track is included in your installation kit as per your wardrobe style.
Typically the top door rail is installed and the doors hung to find the exact positioning of the floor bracket.
This will stop the adjacent paint from.
They make accessing your clothes quicker and also save space where there isn t enou.
Sliding wardrobe doors if the laminate flooring is already laid then you can install the doors directly upon it using the bottom track alone or the liner and track method as described above.
Step 1 remove the old doors.
Angle them toward you as you lower the top guide away from the top track step 2 remove the old tracks.
If you are installing your sliding wardrobe doors directly over an existing carpet then depending on how much the floor slopes or sags you may be able to use packers locally under where the liner is screwed to the floor.
For wooden tracks coated with paint use a utility knife at the edge of the track.
Lift up on the old doors until the rollers come off the track.
Step 2 mark the screw hole locations through the track using a black fine point marker to mark the spots on the carpet.
Sliding doors are a stylish way to improve the function of your wardrobe.
If you want to install completely new sliding doors then start by removing the old doors and tracks.
Fit the sliding doors onto the track as follows.
Step 1 kneel down and measure the bottom of the door opening using a tape measure.
If the gap is reasonably small eg less than 5mm then the carpet should mask the difference.
Tilt the doors and carefully insert the top wheels into the rear channel of the top track.
However if the flooring has carpeting and concrete some preparation is required.
Avoid recessing the track within the laminate floor.
Unscrew the old tracks and pry them off if necessary.
Installing sliding closet doors requires attaching the tracks and slide the panels into position.