If not you may need to go down to the bottom of the first riser to get a neat join.
Fitting carpet runner on stairs.
If you want to know how to remove carpet easily from stairs check this out as companies charge uptown a few hundr.
Ease each bracket apart by taking out the dome headed screw and sliding apart using your fingers.
Tap along the runner to secure it into place by doing so you will ensure a firm hold from the carpet gripper which sits underneath the runner.
When you find a remnant or a piece of carpet it will essentially be cut into sections that will be installed end to end giving the appearance of a seamless runner on the stairs.
The only main difference is that there will be a lot more excess to trim.
Place the bottom part of each pair of brackets either side of the runner adjacent to the carpet edge and in the angle where the tread joins the riser.
Click show more for links and resources stonegate carpets http bit ly 2drtd4w contact us resto.
Fit the carpet runner first.
Even pre made runners are cut into pieces to allow proper fitting to the stairs.
Runners are not installed on the stairs in one piece.
Use carpet tool and rubber mallet to pack runner tightly between the tackless strip and the riser.
Near both ends of the tackless strip staple the runner into the crease where riser meets tread.
Staple each edge of the runner 2 inches above bottom of riser.
Apply firm pressure evenly across the width of the runner with the bolster.
Installing carpet on stairs the right way.
Pull the landing carpet down over the edge of the top step.
Beginning at the top of the stairs measure a stair tread or landing and transfer the measurement to the back of a piece of carpet with marker or chalk.
Gripper and underlay should be used under stair runner carpets in the same way as they are used for any other carpet.
If you have pie shaped or curved stairs install the carpet on the riser in the same way as mentioned above.
90 degree turns these are easy.
Take the stair carpet up to the top of the final riser tack it into place and trim it off in a neat line.
Measure so that the carpet will be flush to the wall and curve completely over the tread.
When a carpet is going up the straight run of the staircase the carpet should be equidistant from the strings of the staircase on both sides so that it lies dead centre on the staircase.
The very last piece of the stair renovation jigsaw.
Secure the runner using the bolster and mallet secure the runner into the groove of the stair.